Panasonic Palmcorder PalmSight PV-L678 - Playback and Viewing

Playing Back your Recordings
la IAEA Before you begin...
WV > Š * Connect the Camcorder to a power source.
LCD Monitor ¢ Insert a recorded cassette.
1 Press the LCD-OPEN button to unlock
the LCD monitor and swing it open.
2 Set the POWER switch to VCR.
* The LCD monitor turns on and off
according to the POWER switch
setting.
* When the LCD monitor is fully open,
the Viewfinder automatically turns
OFF.
+ When the LCD monitor is in the closed
a. ma.
(SE 7 7 ; agt ‘ i
/ ) position, you can view your recording
W j through the EVF.
z * When not in use, close the LCD
an monitor so that it faces inward.
3 Start Tape Playback.
® Press the REWIND/SEARCH
button to rewind the tape.
® Press PLAY to start playback.
© Press STOP to stop playback.
¢ Adjust the volume of the speaker or
earphone (if connected) using the
VOLUME control.
+ Adjust the brightness of the LCD
monitor using the BRIGHT control.
Auto Play
When the POWER switch is set to VCR,
playback will automatically begin if the
record tab has been removed on the
cassette.
Abner you are finished viewing, close
the LCD monitor completely. (The EVF
will turn on.)
Note:
* Using the LCD monitor reduces battery
operating time.
+ If you connect the earphone (M3 type, not
vee
PHONE
supplied)
to
PHONE
(earphone)
jack,
the
sound
`
(earphone)
from
the
speaker
will
be
muted.
j
jack
min.
28