Panasonic Palmcorder PalmSight PV-L678 - Copying Your Tapes (Dubbing)

Copying your Tapes (dubbing)
Before you begin...
+ Connect the Camcorder to VCR as shown
below.
e Turn ON both units.
+ Set the recording VCR's Input Signal
Selector to LINE.
« Set the Camcorder POWER
switch to VCR.
Source (Playing)
Camcorder
1 Insert a pre-recorded tape
into the Camcorder and a blank tape
with a recording tab into your VCR.
2 Press PLAY on the Camcorder and
when you find the starting point, press
STILL.
Audio/Video
Out
3 Press REC on your VCR and then
immediately press STILL/PAUSE.
(To View)
VCR Buttons
VHF Connecting
Cable (not supplied)
PAUSE/STILL STOP REW PLAY FF REC
Recording:
A press STILL on the Camcorder and
press STILL/PAUSE on the VCR to
simultaneously start both units.
To
Audio
5
Press
STOP
on
both
units
when
m In dubbing is complete.
Audio/Video Cable Note:
(supplied) * Tapes recorded on other VCRs and
used for playback in the Camcorder
must be recorded in SP or SLP mode.
¢ For technical reasons, dubbing a tape
may reduce its quality.
Monitor with your TV
¢ Turn the TV ON and select its VCR
channel (CH3 or CH4).
+ Set the VCR/TV Selector on the
recording VCR to VCR.
CAUTION:
Unauthorized exchanging and/or
copying of copyrighted recordings may
be copyright infringement.
45
Y)
©
O
o
J
"Tl
©
99
+
=
-—
©
0