Panasonic Palmcorder PalmSight PV-L679 - Supplying Power

Supplying Power
Charge Battery Pack fully before use.
1 Plug in AC Adaptor. -
POWER Lamp lights.
Lamp 2
1 Insert Battery.
O) Align right side of Battery with line
on AC Adaptor. `
© Press Battery down and slide in
direction of arrow.
CHARGE Lamp lights and then goes
out when charging is done (approx.
1 and 1/2 hours).
3 Remove Battery
Slide Battery out and off.
Note: » Battery life gradually decreases after
After recharging 5 times, use BATTERY repeated use and recharging. If operation
REFRESH feature as explained on page 11. time becomes very short even after a
l sufficient charge, discard Battery properly
(page 11).
Use the Battery Pack
A fully charged Battery provides a maximum of about 2 hours of continuous use (LCD
monitor off) or about 1.5 hours (LCD monitor on). Actual time may vary due to operating
conditions. Using the Built-in Light decreases operating time.
1 Attach Battery
@ Align Battery with top of mounting
surface.
G Press and snap into place.
2 Remove Battery
While sliding BATTERY RELEASE,
remove Battery.