Panasonic Palmcorder PalmSight PV-L679 - Page 38

Security Mode
Before you begin...
« Connect Camcorder to power source.
Use AC Adaptor for longer recordings.
» Insert cassette with record tab (page 13).
» Set POWER to CAMERA.
» Securely position and aim Camcorder.
PAGE 2/2
1 Press MENU for a
MENU mode. MESSAGE or
Press
UP
A
or
VIDEO
ail
DOWN
Y
to
select!
ear.
pisu
vía
KEY
SECURITYE END : PUSH MENU KEY
2 Press DISPLAY for SECURITY
menu. Press +++ SECURITY MODE ---
DOWN ¥ to select OFF
Merle). Press
DISPLAY to
confirm
entry.
ERE
YR
ey
Motion Security may mistakenly start 3 Press MENU for Motion Security
when: stand-by mode. (If cassette
* background is plain, like a white wall, or is not inserted, “ga” will flash.)
has distinct vertical, horizontal, or slanted
stripes, like a venetian blind.
* brightness suddenly changes.
MOTION MOTION
Motion Security may not start when: SECURITY SECURITY
* motion is very slow or fast. STAND-BY
* moving object is very small.
* motion occurs only in 1 corner of viewing
area.
e
Recording
will
start
about
3
seconds
+ in poor lighting (in this case, MOTION after motion is detected
SECURITY flashes). . j A
* background is plain, like a white wall, or * Date and time are recorded if
has distinct horizontal or vertical stripes. displayed in EVF (page 18).
e Recording stops 30 seconds after
Note: motion ceases.
e Security recording starts if Camcorder is
bumped or repositioned. To cancel Security Mode, set Power to
* This feature is not available during normal OFF
recording. Ñ
s While in Security stand-by, the
following functions are not available:
Record/Pause, Stand-by mode, Digital
EIS. Time Lapse, Message, Auto Fade,
Digital Fade.
38