Panasonic Palmcorder PalmSight PV-L757 - Bullt-In Auto AA O

Built-in Auto Light
To improve recording indoors or outdoors in
dim lighting conditions.
Built-in Light Unit Bulb Housing
E
DANGER:
When replacing the bulb, use only lamp bulbs
(PART NO. VLLW0007) supplied by
Panasonic to reduce the risk of fire.
Use a cloth or tissue when handling the bulb
as finger oils will decrease the bulb life.
To prevent possible burn hazard, disconnect
the Bullt-in Light and allow the lamp to cool
before replacing.
CESTA ETA AAA Before you begin...
* Connect the Palmcorder to a power source.
¢ Set the POWER switch to CAMERA.
Set the LIGHT switch to AUTO.
The built-in light automatically turns on and
off depending on lighting conditions.
Or set the LIGHT switch to ON/OFF to
turn the light on and off manually.
SP will appear in the EVF while the light is
turned on.
Caution:
This light becomes hot during operation.
Make sure nothing covers the Light during
operation.
peueis buno
Before you begin...
* Set the POWER switch to OFF.
1 Turn screw counterclockwise and
remove.
2 ® Slide the Built-in Light unit to the
right to unlock (B and remove it.
3 Turn the Bulb Housing counterclock-
wise 1/4 of a turn and pull free from
the Built-in Light unit.
A ising a clean cloth or tissue, replace
the bulb.
5 (& Replace the Bulb Housing by
turning it clockwise. (B) Next, insert the
Built-in Light unit and slide it to the left
to tock it in place. © Finally, replace
the screw.
Note:
* Using the light reduces battery operating time.
* |f using the Built-in Light in a hot environment
for an extended period of time, be sure to
provide ventilation.
* Using the Built-in Light when the Palmcorder is
powered by a car battery may shorten bulb life.
* Be sure LIGHT switch is set to OFF when not
in use or before placing Patmcorder into an
optional carrying caso.
19