Panasonic Palmcorder PalmSight PV-L757 - Playback Using the LCD Monitor

Play Back your Recordings
Playback using the LCD Monitor
You can also use the LCD monitor to
playback your recording.
Before you begin...
* Connect the Palmcorder to a power source.
* insert a recorded cassette.
* Set the POWER switch to VCR.
1 Press the LCD-OPEN button to unlock
the LCD monitor and swing open.
2 Set the LCD-POWER switch to AUTO
ON. The LCD monitor will then turn on/
off according to the Palmcorder's
POWER switch setting.
¢ When the LCD monitor is turned ON,
the Viewfinder automatically turns
OFF.
* When not in use, close the LCD
monitor. (Faces inward)
UJ
fo
o
O
O
Le
(D
=
Q)
=.
o
-
3 Playback the tape (see page 24).
* Adjust the volume of the speaker or
earphone (if connected) using the
VOLUME control.
Z the LCD-POWER switch to OFF to
have Viewfinder on only when viewing is
finished.
* When the LCD monitor is completely
closed, it will shut off automatically to
save power even if the LCD-POWER
switch is left on.
+ When the LCD monitor turns off, the
Viewfinder turns on automatically.
Note:
* Using the LCD monitor reduces battery
operating timo.
* If you connect the earphone (M3 type, not
supplied) to PHONE (earphone) jack, the sound
from the speaker will be muted.
25