Panasonic Palmcorder PalmSight PV-L759 - Page 12

Supplying Power
Charge Battery Pack fully before use. =
l
BATTERY |
PACK
1 Plug in AC Adaptor.
CHARGE
POWER
Lamp
lights.
Lamp
Insert Battery.
G Align right side of Battery with line
on AC Adaptor.
© Press Battery down and slide in
direction of arrow.
CHARGE Lamp lights and then goes
out when charging is done (approx.
1 and 1/2 hours).
3 Remove Battery
Slide Battery out and off.
Note: l s Battery life gradually decreases after
After recharging 5 times, use BATTERY repeated use and recharging. If operation
REFRESH feature as explained on page 13. time becomes very short, even after a
sufficient charge, discard Battery properly
13).
Use the Battery Pack Es
A fully charged Battery provides a maximum of about 2 hours of continuous use (LCD
monitor off) or about 1.5 hours (LCD monitor on). Actual time may vary due to operating
conditions. Using the Built-in Light decreases operating time.
1 Attach Battery
@ Align Battery with top of mounting
surface. .
© Press and snap into place.
\
\ 2 Remove Battery
While sliding BATTERY RELEASE,
remove Battery.
12 For assistance, call 1-800-211-PANA(7262)