Panasonic Palmcorder PalmSight PV-L759 - Page 24

Camera Recording
| Using the LCD Monitor
View recording scene on the LCD (Liquid
Crystal Display).
PHONE (earphone)
jack
Before you begin...
s Connect Camcorder to power source.
* Insert cassette with record tab (page 15).
1 Press LCD-OPEN to unlock LCD.
2 Swing LCD fully open and adjust
viewing angle.
Caution:
Rotating partially open LCD monitor
may block cassette door and damage
Camcorder body.
3 Set POWER to CAMERA.
«LCD monitor turns off/on by the
POWER switch.
. + Viewfinder shuts off when LCD is
fully opened and turns back on
when LCD is closed completely.
e Both Viewfinder and LCD monitor
turn on when LCD is at 180° (see
above left).
This allows both you and the subject
to view the recording.
d Turn BRIGHT control to adjust LCD
brightness level.
5 Press RECORD/PAUSE to start
recording (page 23).
Note:
e Using LCD reduces battery operation time.
s To hear sound while recording, connect
earphone (M3 type: not supplied} to
PHONE jack. Earphone volume cannot be
changed while in CAMERA mode.
* Lock LCD closed when not in use.
24 For assistance, call 1-800-211-PANA(7262)