Panasonic Palmcorder Palmsight PV-L858 - Page 10

Supplying Power
Battery Refresh Feature
This feature completely discharges the Battery before recharging begins.
To maintain your Battery's operating capacity, use the refresh feature after about every five charges.
CHARGE Lamp
x
Í
Plug
in
the
AC
Adaptor.
a * The POWER Lamp remains lit as long as the
AC Adaptor is plugged in.
= 2 Place the Battery into
= >> the AC Adaptor.
:
e
ceee
3
Press
the
BATTERY
REFRESH
button.
The CHARGE Lamp flashes until
discharge is complete and then stays lit
until the Battery is fully charged.
4 Remove the Battery.
e Should you accidentally press the BATTERY
REFRESH button, remove the Battery and
then re-insert it to begin charging.
e it takes about 7 and a half hours when both
Battery Refresh and recharging are
erformed.
Battery Care :
Caution: To avoid damage to the Battery:
« Charge only with specified charger. ¢ Do not drop or jar Battery.
¢ Battery can be charged within a temperature * Use Battery with specified units only.
range of 50° F (10° C) and 95° F (35° C). « If Battery is used in extremely high
* Battery may be warm after charging or just temperatures, a safety device will
after use. This is normal. automatically prevent operation.
¢ Do not use an insufficiently charged or worn-
out Battery. To prolong battery life:
> g «e While not in use, remove Battery from the
e f a P cian ee tdi fin Camcorder and AC Adaptor and store ina
ia ot get the Battery near, or dispose o cool, dark, dry place.
¢
Do
not
directly
connect
(short
circuit)
the
¢
Keep
Battery
terminals
clean.
positive (+) and negative (-) terminals.
+ Never attempt to disassemble or reassemble
the Battery.
U.S.A. CONSUMERS:
ATTENTION:
The product you have purchased is powered by a nickel cadmium battery which is
recyclable. At the end of its useful life, under various state and local laws, it is illegal to
dispose of this battery into your municipal waste stream. Please call 1-800-8-BATTERY
for information on how to recycle this battery.