Panasonic Palmcorder Palmsight PV-L858 - Page 11

Supplying Power
AC Adaptor
DC Power Cable
payeys buno
DC IN I Connect VCR DC OUT on the
a Connector AC Adaptor to DC IN on the
<= a Camcorder with the DC Power
a Cable (supplied).
LS => ¿O
POWER Lamp
pate in the AC Adaptor.
VCR DC OUT Connector
« The POWER Lamp will light.
Notes:
« AC Adaptor cannot be used to power the Camcorder while charging the Battery.
e While not in use, unplug the AC Adaptor from the AC outlet. (When plugged into an AC outlet, the
AC Adaptor consumes 1.2W of electric power when not in use.)
Car Battery Cord (Optional)
I Connect a PV-C16 Car Battery Cord
{optional) to DC IN on the Camcorder.
First, start your car engine, and then
insert the Car Battery Cord plug into
your cigarette lighter socket.
¢ A fuse is located in the tighter plug end of
the cord.
J Should fuse replacement be necessary
a Cigarette Lighter use the exact current rating (in amps),
Socket (12V) Notes:
* This cord can only be used in vehicles
equipped with DC 12V (negative ground)
batteries. Use only the specified car battery
cord. if you are not sure, check with your local
car/truck dealer.
¢ To avoid blowing the fuse, be sure to start your
car engine before inserting the cigarette lighter
Car Battery Cord Cigarette pug of the Car Battery Cord into the lighter
: A socket.
optional Lighter Plug * Because the car is running while your
Camcorder is in operation, make sure
you're in a weil ventilated area.
« Disconnect the cigarette lighter plug when
your Camcorder is not being used.
11