Panasonic Palmcorder Palmsight PV-L858 - Page 32

Playing Back your Recordings in your VCR
Playback using the PlayPak
Remove the Battery Compartment lid
and insert the AA size battery.
e Make sure polarities are aligned properly.
* When tape loading and unloading time
becomes longer than normal, battery replace-
ment is necessary.
1 Turn the Tape Wheel! on the (VHSI]
cassette in the direction of the
arrow to take up any slack.
Z jide the RELEASE button in the
direction of the arrow to open the
PlayPak door.
3 Insert the [VHSIA cassette with the
window facing up and to the left.
Then, snap the lid shut.
* Be sure the cassette reel area under the
PlayPak is free to tum while loading.
+ Allow the Load Detector to fully retract
before using the PlayPak in your standard
VHS VCR.
1 Slide the RELEASE button and wait
for the lid to open.
2 Hold the PlayPak securely in one
hand. Using your finger, reach through
the hole in the bottom of the PlayPak
Adaptor and push the tape out the top.