Panasonic Palmcorder Palmsight PV-L858 - Time Lapse Recording

You can use this feature for security purposes by recording over a long period of time
(up to 6 hours with a T-40 tape).
Before you begin...
<> * Connect the Camcorder to a power source.
4 For extended Camcorder use, the AC Adaptor
pu is recommended as the power source.
— + Insert a cassette with record tab (see page 12).
+ Set the POWER switch to CAMERA.
¢ Slide the TAPE SPEED Selector to SLP.
MENU
DISPLAY
1 Press the MENU button to display
the MENU mode. Press UP A or
DOWN ¥ way to select
* PROGRAMMED REC
TITLE
- TALLY LAMP
- STAND-BY RELEASE
* CLOCK SET SELECT: PUSH ¥/a KEY
- TIME LAPSE ete ee
RECORD/
PAUSE 2 Press the DISPLAY button to set ON
Note (in Time Lapse mode) : or OFF.
+ Sounds can not be recorded. ON:
¢ Picture quality is lower than SLP mode.
* The tape is recorded at 1/3 the speed of SLP. pain
¢ The tape is played back at normal SLP speed i y 6 dealt Nas ese: can then
(3 times faster than it was originally recorded). e played back al Xu Speed.
* Video noise may occur during playback. OFF:
¢ SP/SLP indications will not be displayed. An extended recording (up to 6 hours)
e Titles will not be displayed. ; :
.
Interval
REC
cannot
be
activated.
will
not
be
possible.
You can create an extended recording
o)
O
D
o
D
T
D
T
om ad
c
==
©
0
¢ Vertical jitter may occur depending on monitor 3
used. Press the MENU button to set your
e 10-Second Reminder (see page 19) will not selection and exit this screen.
display during Time Lapse recording.
A press RECORD/PAUSE button for
CAUTION:
recording
START
and
STOP.
* Because recording system for the
Time Lapse feature is not part of VHS
standard, it is recommended to
playback tapes recorded in Time
Lapse mode on this Camcorder.
e Tapes not recorded in Time Lapse
mode may be played back on other
H type camcorders or [VHS] type
S.
T.LAPSE
PAUSE
TIME LAPSE
To cancel Time Lapse mode: Select
NISSAN AS: OFF from the menu
screen.
45