Panasonic Palmcorder Palmsight PV-L858 - Copying Tapes (Dubbing)

Copying your Tapes (dubbing)
Main Operation Before you begin...
¢« Connect the Camcorder to VCR as shown
at left.
( + Turn ON both units.
| * Set the recording VCR's Input Signal
Selector to LINE.
* Set the Camcorder POWER
Ch
E switch to VCR.
I Insert a pre-recorded tape
into the Camcorder and a blank tape
with a recording tab into your VCR.
2 Press PLAY on the Camcorder and
when you find the starting point, press
STILL.
> ee REC on your VCR and then
Out TV immediately press STILL/PAUSE.
(To View)
VCR Buttons
VHF Connecting
o Cable (not supplied) rapa ]<] > ]>] >. |
PAUSE/SSTILL STOP AEW PLAY FF REC
Recording:
VCR 4
————— ee.’ Press STILL on the Camcorder and
TEN. press STILL/PAUSE on the VCR to
simultaneously start both units.
bie Audio T iks Video 5 Press STOP on both units when
i dubbing is complete. .
Audio/Video Cable Note:
(supplied) * Tapes recorded on other VCRs and
used for playback in the Camcorder
must be recorded in SP or SLP mode.
* For technical reasons, dubbing a tape
may reduce its quality.
e Turn the TV ON and select its VCR
channel (CH3 or CH4).
e Set the VCR/TV Selector on the
recording VCR to VCR.
CAUTION:
Unauthorized exchanging and/or
copying of copyrighted recordings may
be copyright infringement.
51