Playing Back Recordings
• uITJl-Jm _h [a.]:q[o] IfJ [:-lvlv|I i[0 i
Connect Camcorder to a IV to view
playback or recordings in progress.
_TV with AUDIO/VIDEO IN Jacks.
Before you begin...
• Connect Camcorder to power source.
• Make all TV-Camcorder connections.
71
2
Set POWER to:
VCR _ view playback.
CAMERA _ view picture as it is
recorded.
Turn TV ON and set to LINE
INPUT.
See TV owner's manual.
To Audio
Audio/Video
Cable
(Supplied)
Begin playback or recording.
To Audio/Video Out
_.TV without AUDIO/VIDEO IN Jacks.
To Audio/
Video Out
f or V.FAntenna
00 ohm-75 ohm
transformer
or F Connector
UHF Antenna
vcwrv
Selector -- Back of TV ---i
VHF Connecting _ I
Cable _l
TO VHFAntenne _ I
Terminal
If TV has no VIDEO/AUDIO IN jacks,
connect PV-RF16 RF Adaotor
_. Tune TV to CH 3 or 4 to
match RF Adaptor 3/4 switch. Set
Adaptor's TV/VCR switch to VCR for
playback.
To watch TV only,
turn TV on without AUDIO/VIDEO IN Jacks
connected (left).
a Set Camcorder POWER to OFF,
b Set RF Adaptor VCR/TV Selector to TV,
c Turn TV ON and select channel.
CATV System Installer
This reminder is provided to call the
CATV system installer's attention to
Article 820-40 of the NEC in USA (and
to the Canadian Electrical Code in
Canada) that provides guidelines for
proper groundingand, in particular,
specifies that the cable ground shall be
connected to the grounding system of
the building, as close to the point of
cable entry as practical.
26 mm=[o]nll';.u-=....._[,._P.nmi_ _ uwahD:(OIO_.,li| m _,1 _.r-¥1P'M-T;f_':,I]
To Next Page
Loading...
