Security Mode
1,2,3
Before you begin.,.
• Connect Camcorder to power source.
Use AC Adaptor for longer recordings.
• insert cassette with record tab (page 13).
• Set POWER to CAMERA.
• Securely position and aim Camcorder.
Press MENU for I J, P_ _'_
11ME ; OFF
MENU mode. !
to selectlsaz.cr,pus,w,_zx /
SET _P_J_IO4SP_YKEY
Press DISPLAY for SECURITY
menu. Press ("... sEcu,rrvuoo=--- _l
DOWNY to select i _ ]
Press| |
mSPLAYto | |
conf'rm entry. _.=cr I _ =v_._ ._
Motion Security may mistakenly start
when:
• background is plain, like a white wall, or
has distinct vertical, horizontal, or slanted
stripes, like a venetian blind.
• brightness suddenly changes.
Motion Security may not start when:
• motion is very slow or fast.
• moving object is very small.
• motion occurs only in 1 corner of viewing
area.
• in poor lighting (in this case, MOTION
SECURITY flashes).
• background is plain, like a white wall, or
has distinct horizontal or vertical stripes.
Note:
• Security recording starts if Camcorder is
bumped or repositioned.
• This feature is not available during normal
recording.
• While in Security stand-by, the
following functions are not available:
Record/Pause, Stand-by mode, Digital
E.I.S., Time Lapse, Auto Fade, Digital
Fade.
3
Press MENU for Motion Security
stand-by mode. (If cassette
is not inserted, "1_'1" will flash.)
II Rcl
MOTION MOTION
SECURITY _ SECURITY
STAND-BY
• Recording will start about 3 seconds
after motion is detected.
• Date and time are recorded if
displayed in EVF (page 19).
• Recording stops 30 seconds after
motion ceases.
To cancel Security Mode, set Power to
OFF,
37
To Next Page
Loading...
