Panasonic Palmcorder PV-D308 - Page 25

Camera Recording
Programmed Recording Before you begin...
l * Connect the Camcorder to a power source.
You can program the Camcorder to start For extended periods of recording, it is
and
stop
recording
at
a
preset
time.
You
recommended
to
use
the
AC
Adaptor
for
a
can
also
do
an
Interval
Recording
which
power
source.
allows you to record 5 or 10 second + Insert a cassette with record tab (see page 12).
intervals per minute. * Set the POWER switch to CAMERA.
1 Press the MENU button to display
. the MENU mode. Press UP A or
DOWN Y repeatedly to select
PROGRAMMED
... MENU ---
Ee.
TITLE ¡ AUTOYMANUAL
: PUSH V/A KEY
SET : PUSH DISPLAY KEY
END : PUSH MENU KEY
2 Press the DISPLAY button to display
the current time in the EVF.
To change the start time, press the
DISPLAY button repeatedly. Each
press increases
the time by 30
minutes.
QU
D
2.
o
O
ES
O
r
c
=
O
5
1020PM
REC TIME ; 10MIN,
RECORD/
i 3
Pue Press DOWN Y to select RIXSI .
Press the DISPLAY button repeatediy
10MIN. — 20MIN. — 30MIN.— TO TAPE END to select one of the recording lengths
2 1 shown at left.
INTERVAL * INTERVAL *
START; 10:30PM
10SEC/MIN.
^"
SSEC/MIN.
CEAL:
10N.
SELECT ; PUSH V/A KEY
SET : PUSH DISPLAY KEY
START ; PUSH REC/PAUSE
CANCEL ; PUSH
*1 Interval 5 SEC/MIN: MENU KEY
A 5 second recording is performed €
each mínute. if you want to cancel the setup, press
*2 Interval 10 SEC/MIN: the MENU button twice.
A 10 second recording is performed
each minute. Z s setting the START and REC
TIME, press the REC/PAUSE button
bran Coder
* The start time cannot be set for over 24
hours in advance from the current time. standby mode: paisa
* The Camcorder will automatically shut leas
itself off when the tape reaches its end or XN. 1 1996
12 hours after an Interval recording is
started. The Camcorder will automatically start
* Set the POWER switch to OFF to cancel recording at the preset time and turn
the Programmed Recording feature. itself off when the recording is finished.
25