Panasonic Palmcorder PV-D308 - Digital E.I.S.; NEG;POS Transposer

Digital E.LS. /NEG/POS Transposer
Digital Electronic Image Before you begin...
Stabilization System * Set the POWER switch to CAMERA.
This feature helps stabilize the picture in
situations such as walking or shooting from
a moving vehicle.
1 Press the ElS button to activate the
Digital E.1.S. function. ("EIS" will
appear in the EVF.)
* The image in the EVF will be
enlarged slightly and the shutter
speed will automatically adjust from
1/80 to 1/350 according to the
brightness of the subject.
2 Press the EIS button again to cancel.
* You may also use the High Speed
Shutter function (from 1/100 to 1/
10000). The shutter speed you select
remains active even after you cancel
the Digital E.1.S. function.
* Be sure that the Digital E.1.S. is
turned off when not in use.
Digital E.!.S. may not function
when...
* Camcorder movement is too ex-
treme.
* recording a subject with distinct
horizontal or vertical stripes.
* recording in low light situations.
* EIS indicator flashes when the light
level is inadequate.
* recording a subject under intense
fluorescent light.
* recording a scene with very fast
motions.
NT TE AUT Before you begin...
This special effect feature allows you to change e Set the POWER switch to CAMERA.
the picture from a positive to a negative image.
Press NEG/POS to view or record a
negative image.
Press again for normal recording.
* Hold down the NEG/POS button for about
3 seconds to activate this feature for the
first time after the power is turned on.
35
o»
po
©
a
m
TI
©
c
mie
=
um !
(D
0