Panasonic Palmcorder PV-D427 - Camera Recording

Camera Recording
Stand-by
Quick
Release
Whenever the Palmcorder is left in RECORD/PAUSE mode
for 5
minutes,
it
will
automati-
cally switch to Stand-by mode to
conserve energy.
Activating
the Stand-by
Quicl<
Release
feature
allows you to release
the
Stand-by
mode
and
resume
recording
by
simply
pressing
the RECORD/PAUSE
button.
If this feature
Is not
activated, it is neces*
sary to turn the Palmcorder OFF and
back on
to
CAMERA t
o
start
recording again. The
default
setting
from
the factory is set
to
the
igwugiwifcTj^
rnQde.
DISPLAY
RECORD/PAUSE
Before you
begin...
•
Connect the
Palnicorder to
a
power
source.
•
Inswt a
cassette
whh
record
tab (see page
10)J
Continue
holding down the UP
button
before and after turning
the
POWER
sw'itch to
CAMERA until
the
STANO-BY
RELEASE menu screen is
displayed.
Press
UP
A
or
DOWN to
select
orl
ACTIVEHaNON-ACTIVE
ACTIVE
STAND-BY
RELEASE
ey RECOROPAUSE KEY
ACTIVE
SafCT:
PUSH T/A KEY
^
BET
; PUSH OtSPLAY KEY
,
You can
resume recording from
Stand-
by
mode
by pressing the
RECORD/
PAUSE
button.
NON-ACTIVE
You must
set
the
POWER'
switch to
OFF, and
then to CAMERA to
release
the Stand-by
mode.
'
Press DISPLAY
to
set your
selection
and
exit
this
screen.
21