Important
Safeguards
15. Power
Lines
—
An
outside
antenna system
should
not
be located in the
vicinity
of overhead power
lines or
ottter eiectric
light
or power circuits,
or
where
it can
fall
into
such power lines or circuits.
Wlien instaliing
an
outside antenna system,
extreme
care should be
taken
to
Iteep
from
touching such power Dnes
or circuits
as
contact
writh
them might
be
fatal.
16.
Overloading
—
Do
not overload wall outlets and
extension cords
as
this can result in a risk of fire
or
electric shock.
17.
Objects
and Liquids
—
Never push objects of any
kind
into
this video
unit through openings as they
may
touch
dangerous
voltage
points
or short
out
parts that could result
in
a
fire
or electric shock.
Never spill liquid of
any
kind
onto the
video
unit.
18. Servicing
—
Do not attempt to
service this video
unit yourself
as
opening
or removing covers
may
expose
you to
dangerous voltage or other hazards.
Refer
all servicing to qualified service personnel.
19.
Damage
Requiring Service
—
Unplug
this video
unit from
the wall
outlet and
refer sen/icing
to
qualified
service
personnel under the
following
conditions:
a.
When
the power-supply cord or plug is
damaged.
b. if any liquid has
been spilled
onto, or objects
have
fallen into the
video unit
c. If the
video
unit has
been exposed to
rain
or
water.
d.
If
the video unit
does
not operate
normally
by
following
the operating instructions. Adjust
only
those controls that are
covered
by the
operating
instnjctions,
as
an
improper
adjustment of other
controls may result
in
damage and
will
often
require extensive wofk by
a
qualified technician
to
restore the video unit
to
its
normal
operation.
e.
If
the
video unit
has been dropped
or the cabinet
has been damaged.
f. When
the video unit exhibits
a
distinct change
in
performance
—
this indicates
a
need
forsenrice.
20.
Replacement Parts
—
When
replacement
parts
are
required,
be
sure
the
service technteian
has
used
replacement parts specified by the
manufacturer
or
have the same characteristics as the
original part
Unauthorized
substitutions may result in fire,
electric shock or other hazards.
21 . Safety Check— Upon completion of any service or
repairs to this video unit, ask the service
technician
to
perform safety
checks to determine
that the
video
unit is in safe operating order.
Precautions
USE & LOCATION
•
TO AVOID
SHOCK
HAZARD ... Your Camcorder and
power supply should
not be exposed
to
nan or
moisture.
Do not connect
the power supply or operate
your Camcorder
if
it
gets
wet. Your Camcorder has been designed
for
outdoor use, however it
is not designed
to
sustain
direct exposure
to
water,
rain,
sleet, snow, sand,
dust,
or
a
direct splashing from
a pool
or even
a cup
of coffee.
This
action could pemianently damage the internal
parts
of
your Camcorder.
Do not attempt
to
disassemble this unit.
There
are
no
user
sen/iceable parts insid& Unplug
your Camooider from
the power supply
before
cleaning.
•
DO NOT AIM
YOUR
CAMCORDER AT THE SUN OR OTHER BRIGHT OBJECTS
•
DO NOT LEAVE
THE PALMCORDER WITH THE EVF AIMED DIRECTLY AT THE SUN
AS
THIS MAY
CAUSE DAMAGE
TO
THE
INTERNAL PARTS
OF THE EVF
•
DO NOT
EXPOSE YOUR
CAMCORDER TO EXTENDED HIGH TEMPERATURE ... Such
as,
in
direct
sunlight,
inside
a dosed car.
next
to a
heater,
etc...
This action could
pemianently damage the
internal
parts of your
Camcorder.
•
AVOID SUDDEN CHANGES
IN TEMPERATURE ... If
the unit is Suddenly moved from
a
cold
place to a
warm
place,
moisture may form
on the
tape
and inside the unit.
•
DO NOT LEAVE YOUR
CAMCORDER
OR THE
POWER
SUPPLY
TURNED
ON WHEN NOT IN USE.
•
STORAGE OF YOUR
CAMCORDER ...
Store and handle your Camcorder
in
a
manner
that
will not subject
it
to
unnecessary
movement
(avoid
shaking
and
striking).
Your Camcorder contains
a
sensitive
pick-up device
wNch
could
be
damaged
by improper handling or
storage.
CARE
•
TO CLEAN
YOUR
CAMCORDER ...
Do not
use
strortg
or abrasive detergents
when cleaning
your Camcorder
body.
•
TO PROTECT
THE LENS ...
Oo not touch the surface Of the lens
with your
hand.
Use a
commercial camcorder
lens
solution and
lens
paper
when
cleaning the lens. Improper cleaning can scratch the lens coating.
•
TO
PROTECT THE
FINISH
OP YOUR CAMCORDER ... Before handling your Camcorder,
make sure your
hands
and face
are
free from any chemical
products, such as suntan lotion, as
it
may damage the finish.
4
To Next Page
Loading...
