Panasonic Palmcorder PV-D427 - Supplying Power

Supplying Power
Charge
the
Battery
Pack
Charge
the Battery
Pack fully
before operation.
POWER
Lamp
CHARGE
Lamp
Note:
After
recharging
the Battery Pack
about
5
times,
use the BATTERY REFRESH feature
as
explEtined
ort
page 8.
Use the Battery Pack
Plug
in
the AC Adaptor.
POWER
Lamp
lights.
Insert
the Battery
®
Align the right side of the Battery with
the
line on
the
AC Adaptor.
(§)
Press the Battery down and slide it
in
the
direction of the
arrow.
CHARGE Lamp lights. When
charging
is
done
(about one and a
half
hours)
the
lamp
goes
out.
*
Remove
the Battery
Slide the Battery
out
and lift
up.
•
The
useful operation time of the Battery
will
gradually decrease after repeated
use
and
recharging. The Battery is no longer
serviceable
If
the operation time is
very
short,
even after a sufficient charge.
With a fully charged
Battery Pacl<.
you
will
have
a
maximum
of
about
one and
a half
hours of continuous
use.
(If
the Built-in Light is
used, battery
operating
time decreases.)
Attach the Battery
(S>
Align the Battery with
the
top of
the
mounting
surface.
(D
Press it
Into place
until
it
locks
with
a
clicl<.
Remove
the Battery
While
sliding the
BATTERY
RELEASE
button,
remove the Battery.
7