Panasonic Palmcorder PV-D427 - Page 8

Supplying Power
Battery
Refresh
Feature
This
feature
completely
discharges the
Battery before recharging begins.
To maintain
your
Battery's
operating
capacity, use the refresh
feature
after
about every
five
charges.
CHARGE Lamp
_
Y
L Plug in the AC
Adaptor.
The
POWER Lamp
remains lit
as
long
as
the
AC
Adaptor rs plugged
in.
Place
the
Battery
into
the
AC
Adaptor.
Press
the BATTERY
REFRESH
button.
The
CHARGE
Lamp
flashes until
discharge is
complete and
then
stays
lit
until
the
Battery
is
fully charged.
Remove
the
Battery.
•
Should
you
accidentally
press the BATTERY
REFRESH button,
remove
the
Battery
and
then
re-insert it to
begin charging.
•
It takes
about seven
and a half
hours
when
both
Battery
Refresh
and
recharging
are
performed.
To
avoid
damage
to the Battery:
•
Do
not
drop
or jar
Battery.
•
Use
Battery
with
specified
units only.
•
If
Battery
is used
In
extremely high tempera-
tures,
a safety
device
will automatically
prevent operation.
Battery Care
Caution:
«
Charge only
with
specified
charger.
•
Battery
can be
charged
within a temperature
range of
32°
F
(O" C) and
104"
F
(40°
C).
•
Battery
may be
warm
after charging or
just
after use.
This is normal.
•
Do not
use
an insufficiently
charged or worn-
out Battery.
To
prolong battery
life:
•
While
not
in
use. remove Battery from
the
Palmcorder and AC
Adaptor and store
in a
cool,
dark,
dry place.
•
Keep
Banery
terminals
clean.
Safety
precautions:
•
Do not
get
the Battery
near,
or
dispose
of
in
fire.
•
Do
not
directly connect
(short
circuit) the
positive
(+)
and negative
(-}
terminals.
•
Never
attempt
to disassemlsle
or
reassemble
the Battery.
U.S.A.
CONSUMERS:
ATTENTION:
The
product
you
have
purchased is powered by
a
nickel cadmium
battery
which
is
recyclable.
At the end of its
useful
life, under
various
state
and
local
laws, it is
illegal
to
dispose
of this
battery into
your
municipal
waste
stream.
Please
call 1-800-8-BATTERY
(or information
on
how to recycle
this
battery.
j
8