Panasonic Palmcorder PV-D427 - Page 9

Supplying Power
AC Adaptor
—
DC Power Cable
POWER Lamp
DC IN
Connector
VCR
DC OUT Connector
Connect VCR
DC
OUT on the
AC Adaptor
to
DC
IN on the
Palmcorder with the
DC
Power
Cable
(supplied).
Plug In the
AC
Adaptor.
The POWER
Lamp
will
light
Notes:
•
AC Adaptor cannot be used to power the Palmcorder while charging
the
Battery.
•
While
not
in
use,
unplug the AC Adaptor from the
AC
outlet. (When
plugged into an AC outlet, the
AC Adaptor
corisumes
1 .2W
of electric power
when
not
in
use.)
Car Battery Cord (Optional)
DC
IN
Connector
Cigarette Lighter
Socket
(12V)
Car Battery
Cord
(optional)
Cigarette
Lighter Plug
A. Connect a PV-C16 Car Battery Cord
(optional)
to DC
IN
on the Palmcorder.
2First, start your car engine,
and then
insert the Car Battery Cord plug into
your cigarette
lighter
socket.
•
A fuse is
located in the lighter plug
end of
the cord.
Should
fuse
replacement be necessary
use the exact current rating (in
amps).
Notes:
•
This
cord can only be used in vehicles
equipped
with
DC
12V
(negative
ground)
batteries. Use only the specified
car battery
cord. If you are not sure, check with
your local
car/truck dealer.
•
To avoid
blowing
the fuse, be sure
to start your
car
engine
before inserting the
cigarette lighter
plug
of
the Car Battery
Cord into the
lighter
socket.
•
Because the car is
running while
your
Palmcorder is in operation, make
sure
you're
in
a
well ventilated area.
•
Disconnect the cigarette lighter
plug
when
your Palmcorder Is not being
used.
9