Before Use
Selecting Remote Controller Modes
When 2 Camcorders are used simultaneously,
they can be operated individually by selecting
different Remote Controller Modes.
• If the Remote Controller Mode of the
Camcorder and that of the Remote Controller
do not match, [REMOTE] Indication is
disp{ayed.
Setup on the Camcorder."
Set [REMOTE] on the [INITIAL] Sub-Menu to the
desired Remote Controller Mode. (-2J-)
Setup on the Remote Controller:
[VCR1]: Press the [1_-]Button and [11] Button
simultaneously, 0
[VCR21:Press the [-,I]Buttonand [11]Button
simultaneously. 0
• When the battery in the Remote Controller is
replaced, the mode is automat{cally reset to
[VCR1] Mode.
_Supp/y ..............................................................
• Using the AC Adaptor
0
1 Connect the DO Cable to the Camcorder.
2 Connect the DO Cable to the AC Adaptor.
3 Connect the AC Cable to the AC Adaptor
and the AC Jack.
• The AC Cable's outlet plug does not fit
entirely into the AC Adaptor jack. A gap will
remain as shown O.
• Before connecting or disconnecting the
power supply, set the [OFF/ON] Switch on
the Camcorder to [OFF] and make sure that
[POWER] Lamp is not lit.
• Using the Battery
Before use, fully charge the Battery.
• We recommend using a Panasonic Battery.
• We cannot guarantee the quality of this
Camcorder when batteries from other
companies are used.
1 Attach the Battery to the AC Adaptor and
charge it.
• Since the Battery will not be charged when
the DC Cable is connected to the AC
Adaptor, disconnect it from the AC Adaptor.
• The [CHARGE] Lamp lights up, and charging
starts.
• When the [CHARGE] Lamp goes off,
charging is completed.
• When the battery is completely discharged,
the [CHARGE] lamp blinks at first, but the
battery is charged normally. When the
temperature of the battery is too high or low,
the [CHARGE] lamp blinks and the charging
time becomes longer than usual.
2 Attach the charged Battery to the
Camcorder.
Disconnecting the Power Source
Set the [OFF/ON] Switch i_ to [OFF] and, while
pressing the [PUSH BATT] Button i_, slide the
Battery or DC Cable upward to disconnect it.
• For other notes concerning this item, see *Tt*.
-15-
To Next Page
Loading...
