Before Use
4) [DIGITAL]
Playback Digital Setup Sub-Menu
[TITLE IN]
Adding a Title .47-
5) [DISPLAY]
Display Setup Sub-Menu
[DISPLAY]
Display Mode -69-
[DATE/TIME]
Date and Time Indication -69-
[C.DISPLAY]
Counter Display Mode -69-
[C.RESET]
Counter Reset-84-
6) [LCD/EVF]
Adjusting Brightness and Color Level
[LCD All (PV-GS20O only)
Intelligent LCD Monitor-21-
[LCD/EVF SET]
LCD and Viewfinder Adjustment -20-
[EVF ON/AUTO]
Using the Viewfinder .2o-
7) [INITIAL)
Initial Setup Sub-Menu
[AV JACK]
AV Jack -82-
[REMOTE]
Remote Controller Mode -]6-
• tl_ [MPEG4 PLAYBACK MODE]
(PV-GS200 only)
MPEG4 PlaybackMenu
[DATE/TIME]
Date and Time Indication -69-
4) [LCD/EVF]
Adjusting Brightness and Color Level
[LCD All (PV-GS20O only)
Intelligent LCD Monitor-2t-
[LCD/EVF SET]
LCD and Viewfinder Adjustment -2o-
[EVF ON/AUTO]
Using the Viewfinder -20-
5) [INITIAL]
Initial Setup Sub-Menu
[AV JACK]
AV Jack -82*
[REMOTE]
Remote Controller Mode -]6-
Setting Date and Time
Since the internal clock of the Camcorder has a
slight imprecision make sure to check the time
before recording
1 Set [TAPE RECORDING MENU] or
[CARD RECORDING MENU] >> [INITIAL] >>
[CLOCK SET] >> [YES].
llCLOC_ SET I
1) [DELETE]
Deleting a File Sub-Menu
[FILE BY SELl
Selecting and Deleting a File .49-
[ALL FILES]
Deleting All Files -49-
2) [EDITING]
Editing e File Sub-Menu
[FILE LOCK]
Setting the Lock -48-
[CARD FORMAT]
Formatting a Card -49-
3) [DISPLAY]
Display Setup Sub-Menu
[SCREEN]
Screen Setting
[DISPLAY]
Display Mode -69-
2 Press the [II/M] Button to select [YEAR],
[MONTH], [DAY], [HOUR] or [MIN.] and
press the [<I</IH_] Button to set it to the
desired value.
eYear will cycle in the order shown below.
2000, 2001, ._, 2089, 2000 ....
3 Press the [MENU] Button 1:_ to finish
setting the date and time.
eThe clock operation starts from [00] second.
• If the built-in battery is weak, the [_] or [--]
Indication flashes. In this case, charge the
built-in battery.
• The clock uses the 12-hour system.
-25-
To Next Page
Loading...
