Playback mode
42
LSQT1091
Playback mode
Playing back tape
≥Set to Tape Playback Mode.
(An operation icon automatically appears on
the LCD monitor.)
1 Operate with joystick.
1/;: Playback/Pause
6: Rewind/Review playback (Reverts to
playback with the 1/; icon.)
5: Fast forward/Cue playback (Reverts to
playback with the 1/; icon.)
∫:Stop
≥The power will not turn off when the LCD
monitor and the viewfinder are closed and
retracted during Tape playback mode.
≥During cue/review playback, fast-moving
images may show noise as a mosaic.
≥Before and after cue/review playback, the
screen may become blue for a moment or
images may be disturbed.
ª
To adjust volume
Adjust the speaker volume for playback.
1 Move the [s /VOLr] lever to adjust the
volume.
Towards [r]: increases the volume
Towards [`]: decreases the volume
(The nearer the bar is to [r], the higher the
volume.)
≥On the remote control, press the [T] button to
increase the volume or the [W] button to
decrease it.
≥When the adjustment is completed, the volume
indication will disappear.
≥If you do not hear the sound, check the settings
of [SETUP] >> [12bit AUDIO].
ª
Repeat playback
When the tape end is reached, the tape will be
rewound and played back again.
1 Set [ADVANCED] >> [REPEAT PLAY] >>
[ON].
≥The [ ] indication appears. (In order to
cancel the repeat playback mode, set
[REPEAT PLAY] >> [OFF] or turn off the
power.)
≥When you set [USB FUNCTION] >>
[WEB CAM] and then connect the USB cable,
the repeat playback mode is canceled.
ª
Settings on the audio
≥If you cannot listen to the desired audio when
playing back a tape, check the settings in
[SETUP] >> [12bit AUDIO].
≥When you record and dub the audio in [12bit]
and set [SETUP] >> [12bit AUDIO] >> [MIX], the
audio will be played back in stereo sound
regardless of the settings in [AUDIO OUT].
VOL
LSQT1091_ENG.book 42 ページ ２００６年１１月２７日 月曜日 午後１時１７分
To Next Page
Loading...
