]
3
2
®
/
\ I /
\ /
buttonLIGHTRELEAS_
To brighten the natural colors in a scene.
1
Slide Light into built-in Light Mount.
Be sure it locks into place.
2
LIGHT
Press LIGHT button ON.
To remove the Light:
RELEASE
Press Light RELEASE button
(_) and slide the Light out of the mount.
CAUTION:
This light becomes hot during operation.
ULB
CASING
irDanger:
• When replacingthe bulb, use only lamp bulbs
(_PARTNO. VLLW0003) supplied by
Panasonic to reduce the risk offire.
Use a cloth or tissue when handlingthe bulb
as finger oils will decrease the bulb life. To
revent possible burn hazard, disconnect the
olor Enhancement Light Un t and allow the
lamp to cool before replacing.
Do not connect any light other than the
standard light included. Use of a different light,
modification to the light connector or light jack
may cause severe battery drain and fire
_. hazard, j
16
Turn screw counterclockwise
on the underside ofthe reflector casing
and remove.
Turn reflector casing counter-
clockwise only as far as shown inthe
diagram and pull it off the bulb housing.
Using a clean cloth or tissue, replace
the bulb.
Replace the reflector casing
turning it clockwise. Replace the screw.
Note:
• Ifusing the Enhancement Light for an
extended period of time, be sure to
provide ventilation when using in a hot
environment.
• Using the Enhancement Light when the
Palmcorder is powered by a car battery
may shorten bulb life.
• Do not attempt to lift or carry the
Palmcorder by holding the Enhancement
Light.
To Next Page
Loading...
