Panasonic Palmcorder PV-S64 - Camera Recording; Easy Edit Standby and Manual Editing

_OWERSwitch_
18
If you stop recording but plan to resume
within 24 hours, use the Edit Standby
feature to make a smooth transition
between scenes.
Set the POWER switch to OFF while in
Record/Pause mode and leave the
cassette inthe Palmcorder.
Set the POWER switch to CAMERA and
press RECORD/PAUSE (within 24 hours)
to continue recording.
Note:
• If it is longer than 24 hours before you
resume recording, use the manual Easy
Edit feature described below.
For proper continuity when taping from the
Stop mode, or after charging the Battery
Pack. POWER
VCR OFF CAMERA
the POWER switch to VCR,
Press REWIND to go back a
few seconds on the tape.
Then, press PLAY to review
the picture on the Viewfinder.
STILL
switch to CAMERA.
willgo into the Record/
mode. _
Press RECORD/PAUSE to continue
recording.
Now, press STILL at the
location you wish to continue
your recording.
POWER
REW
Press REWIND while in Record/Pause
mode to review the last few seconds of
your recording.