Before you begin...
• Connect the external Microphone (if used).
• Turn On the Palmcorder.
• Insert a cassette (with tab) to be recorded.
• When using the RF Adaptor to monitor, turn
the TV ON and select CH 3 or 4 (see page
24).
Connection
.111Audio/Video Cable (supplied)
_111t or RF Adaptor (supplied: PV-S64)
. .11| (optional: PV-54)
m°niz°qll __
• To Audio/Video In
DC Output
Connector
DC Power Cable
1
[]
DC Input
Connector
Top View I
r
3 2
o A.DUB o V.DU_,.,_ COUNTER
/ RESE'T',_DISPL AY
('- REW PLA_ FF STO]_,_ STILL
Your own sound track may be substituted
onto a tape using an external microphone
or the built-in microphone on your
Palmcorder. POWER
VCR OFF CAMERA
Set the POWER switch to VCR.
PLAY STILL
Press PLAY.
Then press STILL where you want
dubbing to begin.
0 A.DUB
3
Press AUDIO DUB to put the Palmcorder
inthe Audio Dub Pause mode.
4
Press STILL to start Audio Dubbing.
Connect Palmcorder to TV in order to
monitor sound. (Audio Out Selector must
be set to MIX or NORMAL).
5
Press STOP to stop Audio Dubbing.
Refer to page 38 for Memory-Stop
Editing.
If the microphone used for dubbing, gets
too near the speaker of your TV,
a howling noise (feedback) may occur.
The new audio portion is recorded on
the Normal (mono) track. When you
playback the recording, you may fisten to
the original Hi-Fi sound, the audio
dubbed Normal sound or both by using
the AUDIO OUT SELECTOR switch.
(See page 21.)
37
To Next Page
Loading...
