31
LSQT1394
Setup
3
Setting date and time
When the unit is turned on for the first time, a message asking you to set the date and time will appear.
Select [YES] and press the joystick. Perform steps 2 and 3 below to set the date and time.
¬Rotate the mode dial to select or .
1 Select the menu. (l 28)
2 Select the date or time, then
adjust the desired value with the
joystick.
≥ The year will change as follows:
2000, 2001, ..., 2099, 2000, ...
≥ The 12-hour system is used to display the time.
3 Press the joystick to enter the
selection.
≥ The clock function starts at [00] seconds when
the joystick is pressed.
4 Press the MENU button to finish
the setting.
≥ Check the date and time displayed.
∫ Changing the date and time display mode
Select the menu. (l 28)
[SETUP] # [DATE/TIME] # desired display
style
∫ Changing the date format
Select the menu. (l 28)
[SETUP] # [DATE FORMAT] # desired
display style
≥ The date and time function is driven by a built-
in lithium battery.
≥ If the time display is [- -], the built-in lithium
battery needs to be charged. Use the following
steps to charge the battery, and then set the
date and time.
To recharge the built-in lithium battery
Connect the AC adaptor or insert the battery to
the unit, and the built-in lithium battery will be
recharged. Leave the unit as it is for approx.
24 hours and the battery will save the date and
time for approx. 6 months. (Even if the mode
dial is set to OFF, the battery is still being
recharged.)
[BASIC] # [CLOCK SET] # [YES]
[DATE] [D/T]
[OFF]
Display style Screen display
[Y/M/D] 2008.NOV.15
[M/D/Y] NOV.15.2008
[D/M/Y] 15.NOV.2008
NOV.15.2008 NOV.15.2008 12:34 PM
SDR-H60P&PC-LSQT1394_mst.book 31 ページ ２００８年３月４日 火曜日 午後２時３５分
To Next Page
Loading...
