4. 5. Basic format
Data streaming from the computer will start with STX, and proceed to command, parameter and end with ETX.
Parameters can be added as necessary.
4. 6. Control commands
Refer to Operating Instructions of PT-AE8000 / PT-AT6000.
End (03h)Start byte(02h) 3 bytes
・The projector can not receive any command for 10 seconds after the lamp is switched on. Wait 10 seconds before
sending the command.
・If sending multiple commands, check that a response has been received from the projector for one command
before sending the next command.
・When a command which does not require parameters to be sent, the colon (:) is not required.
・If an incorrect command is sent from the personal computer, the ER401 command will be sent from the projector
to the personal computer.
STX Command
：
Parameter
1 byte 1byte - 4 bytes
ETX
INF - 9
To Next Page
Loading...
