1. 4. Serial Number Setup
1. 4. 1. Required equipments
1. PC : Use it as adjustment use.
2. Communication cable : D-sub 9pin (male/emale RS-232C straight)
3. Software : ［Service ORCA11.exe］Adjustment software is downloaded from the projector service homepage.
1. 4. 2. Preparation
1. 4. 3. Setting method
1. Switch the projector to "Standby" mode (POWER indicator is Lighting in red).
2. Start up service software ［Service ORCA11.exe］ with a computer.
3. Select language and click the [ OK ] button.
4. 1) Select the Serial Port of the computer.
2) Select a model number.
(Case of AT6000, select the AE8000.)
3) Click the [ Data ] button.
5. Click the [ Set up ] button of Serial Number.
6. Input the product serial number, and click the [ Send ] button.
1. Connect the RS-232C termanal of projector
and PC with a RS-232C cable.
Compute
Projecto
RS-232C cable (Streight)
③
①
②
ADJ - 5
To Next Page
Loading...
