Panasonic PT-FRQ50 - [Control Device Password Change]

Chapter 4 Settings — [SECURITY] menu
134 - ENGLISH
8) Press
qw
to switch the item.
[ENABLE]
Enables button operations.
[DISABLE]
Disables button operations.
9) Press
as
to select [APPLY], and press the <ENTER> button.
f
The conrmation screen is displayed.
10) Press
qw
to select [OK], and press the <ENTER> button.
Note
f
When a button operation is performed on the device set to [DISABLE], the
[CONTROL DEVICE PASSWORD]
screen is displayed.
Enter the control device password.
f
The
[CONTROL DEVICE PASSWORD]
screen will disappear when there is no operation for approx. 10 seconds.
f
If the operations of both [CONTROL PANEL] and [REMOTE CONTROL] are set to [DISABLE], the projector cannot be turned o󰀨 (cannot
enter standby).
f
When the setting has completed, the menu screen will disappear. To operate continuously, press the <MENU> button to display the main
menu.
f
Even when you set button operations on the remote control disabled, operations of the <ID SET> and <ID ALL> buttons on the remote
control are kept enabled.
[CONTROL DEVICE PASSWORD CHANGE]
The control device password can be changed.
1) Press
as
to select [CONTROL DEVICE PASSWORD CHANGE].
2) Press the <ENTER> button.
f
The
[CONTROL DEVICE PASSWORD CHANGE]
screen is displayed.
3) Press
asqw
to select the text, and press the <ENTER> button to enter the text.
4) Press
asqw
to select [OK], and press the <ENTER> button.
f
To cancel, select [CANCEL].
Attention
f
The initial password is “AAAA” by the factory default setting, or after initialized by one of the following methods.
g
When initialized by selecting the [PROJECTOR SETUP] menu → [INITIALIZE] → [FACTORY RESET]
g
When initialized by setting the [PROJECTOR SETUP] menu → [INITIALIZE] → [USER SETTINGS] → [OTHER USER SETTING] to
[INITIALIZE]
f
Change the password periodically that is hard to guess.
f
To initialize your password, consult your distributor.