Panasonic PT-FRQ50 - [Wired Lan]; [Wireless Lan]

Chapter 4 Settings — [NETWORK] menu
ENGLISH - 137
Note
f
[DIGITAL LINK MENU] cannot be selected when the [NETWORK] menu
→
[DIGITAL LINK]
→
[EXTRON XTP] is set to [ON].
[EXTRON XTP]
Make connection setting for the "XTP transmitter" of Extron Electronics.
1) Press
as
to select [DIGITAL LINK].
2) Press the <ENTER> button.
f
The
[DIGITAL LINK]
screen is displayed.
3) Press
as
to select [EXTRON XTP].
4) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[OFF]
Select this item when connecting the optional DIGITAL LINK output supported device (Model No.:
ET-YFB100G, ET-YFB200G) to the <DIGITAL LINK/LAN> terminal.
[ON]
Select this item when connecting the “XTP transmitter” of Extron Electronics to the <DIGITAL LINK/
LAN> terminal.
Note
f
For details of the “XTP transmitter”, visit the website of Extron Electronics.
URL http://www.extron.com/
[WIRED LAN]
Perform the connection setting to use the wired LAN.
1) Press
as
to select [WIRED LAN].
2) Press the <ENTER> button.
f
The
[WIRED LAN]
screen is displayed.
3) Press
as
to select an item, and change the settings according to the operation instructions of the
menu.
[DHCP]
[ON]
If a DHCP server exists in the network where the projector is to be
connected, obtains the IP address automatically.
[OFF]
If a DHCP server does not exist in the network where the projector
is to be connected, set [IP ADDRESS], [SUBNET MASK], and
[DEFAULT GATEWAY].
[IP ADDRESS]
Enter the IP address when a DHCP server is not used.
[SUBNET MASK]
Enter the subnet mask when a DHCP server is not used.
[DEFAULT GATEWAY]
Enter the default gateway address when a DHCP server is not used.
4) Press
as
to select [STORE], and press the <ENTER> button.
f
The conrmation screen is displayed.
5) Press
qw
to select [OK], and press the <ENTER> button.
Note
f
When using a DHCP server, conrm that the DHCP server is running.
f
Consult your network administrator regarding the IP address, subnet mask, and default gateway.
f
The network setting is common for the <LAN> terminal and the <DIGITAL LINK/LAN> terminal.
f
[WIRED LAN] cannot be selected when the [NETWORK] menu
→
[Art-Net]
→
[Art-Net SETUP] is set to [ON(2.X.X.X)] or [ON(10.X.X.X)].
f
Wired LAN and wireless LAN cannot be used in the same segment.
[WIRELESS LAN]
Set the connection method of wireless LAN and its details.
f
To use the wireless LAN function with the projector, it is necessary to attach the optional Wireless Module (Model
No.: AJ-WM50 Series) to the <USB (DC OUT)> terminal.
1) Press
as
to select [WIRELESS LAN].