Panasonic PT-FRZ50 - Page 103

Chapter 4 Settings — [PROJECTOR SETUP] menu
ENGLISH - 103
Note
f
The [STANDBY MODE] setting will be forced to [NORMAL] when the [PROJECTOR SETUP] menu
→
[ECO MANAGEMENT]
→
[STANDBY
MODE] is set to [ECO], and [SCHEDULE] is set to [ON]. Changing the setting to [ECO] is not available. The [STANDBY MODE] setting will
not change back even when [SCHEDULE] is set to [OFF] in this condition.
How to assign a program
1) Press
as
to select [SCHEDULE].
2) Press
qw
to select [ON], and press the <ENTER> button.
f
The
[SCHEDULE]
screen is displayed.
3) Select and assign a program to each day of week.
f
Press
as
to select the day of week, and press
qw
to select a program number.
f
You can set the program from No.1 to No.7. “- - -” indicates that the program number has not been set.
How to set a program
Set up to 16 commands to each program.
1) Press
as
to select [SCHEDULE].
2) Press
qw
to select [ON], and press the <ENTER> button.
f
The
[SCHEDULE]
screen is displayed.
3) Press
as
to select [PROGRAM EDIT].
4) Press
qw
to select a program number, and press the <ENTER> button.
5) Press
as
to select a command number, and press the <ENTER> button.
f
You can change the page using
qw
.
6) Press
asqw
to select [TIME], and press the <ENTER> button.
f
The projector is in the adjustment mode (the time is blinking).
7) Press
qw
to select “hour” or “minute”, and press
as
or the number (<0> - <9>) buttons to set a
time, and then press the <ENTER> button.
8) Press
asqw
to select [COMMAND].
9) Press the <ENTER> button.
f
The
[COMMAND]
detailed screen is displayed.
10) Press
as
to select a [COMMAND].
f
For [COMMAND] which requires detailed settings, the items of the detailed settings will switch each time
you press
qw
.
f
When [INPUT] is selected, press the <ENTER> button, and then press
asqw
to select the input to be
set.
[COMMAND]
Detailed settings of
[COMMAND]
Description
[POWER ON]
― Switches on the projector.
[STANDBY]
― Enters standby.
[QUICK STARTUP]
[ON]
Enables the function of the [PROJECTOR SETUP] menu
→
[ECO
MANAGEMENT]
→
[QUICK STARTUP].
[OFF]
Disables the function of the [PROJECTOR SETUP] menu
→
[ECO
MANAGEMENT]
→
[QUICK STARTUP].
[SHUTTER]
[OPEN]
Disables the shutter function (shutter: open).
[CLOSE]
Enables the shutter function (shutter: closed).