Panasonic PT-FRZ50 - [Control Device Password Change]

Chapter 4 Settings — [SECURITY] menu
ENGLISH - 119
5) Press
as
to select [CONTROL PANEL] or [REMOTE CONTROL].
6) Press
qw
to switch [USER].
7) Press
as
to select the button item to set.
f
When [INPUT SELECT BUTTON] is selected in [REMOTE CONTROL], press the <ENTER> button, and
then press
as
to select the button to set.
Buttons that can be set
[CONTROL PANEL] [REMOTE CONTROL]
[POWER BUTTON]
Power <
v
/
b
>button
[INPUT SELECT BUTTON]
<INPUT SELECT> button
<COMPUTER 1> button, <COMPUTER 2>
button, <VIDEO> button, <HDMI 1> button,
<HDMI 2> button, <DIGITAL LINK> button
[MENU BUTTON]
<MENU> button
[AUTO SETUP BUTTON]
― <AUTO SETUP> button
[ON SCREEN BUTTON]
― <ON SCREEN> button
[OTHER BUTTON]
asqw
, <ENTER> button Buttons not listed above
8) Press
qw
to switch the item.
[ENABLE]
Enables button operations.
[DISABLE]
Disables button operations.
f
When [INPUT SELECT BUTTON] is selected in Step
7)
, pressing the <MENU> button returns to the
[CONTROL PANEL]
screen or the
[REMOTE CONTROL]
screen once the item is switched.
9) Press
as
to select [APPLY], and press the <ENTER> button.
f
The conrmation screen is displayed.
10) Press
qw
to select [OK], and press the <ENTER> button.
Note
f
When a button operation is performed on the device set to [DISABLE], the
[CONTROL DEVICE PASSWORD]
screen is displayed.
Enter the control device password.
f
The
[CONTROL DEVICE PASSWORD]
screen will disappear when there is no operation for approx. 10 seconds.
f
If the operations of both [CONTROL PANEL] and [REMOTE CONTROL] are set to [DISABLE], the projector cannot be turned o󰀨 (cannot
enter standby).
f
When the setting has completed, the menu screen will disappear. To operate continuously, press the <MENU> button to display the main
menu.
f
Even when you set button operations on the remote control disabled, operations of the <ID SET> and <ID ALL> buttons on the remote
control are kept enabled.
[CONTROL DEVICE PASSWORD CHANGE]
The control device password can be changed.
1) Press
as
to select [CONTROL DEVICE PASSWORD CHANGE].
2) Press the <ENTER> button.
f
The
[CONTROL DEVICE PASSWORD CHANGE]
screen is displayed.
3) Press
asqw
to select the text, and press the <ENTER> button to enter the text.
4) Press
asqw
to select [OK], and press the <ENTER> button.
f
To cancel, select [CANCEL].
Attention
f
The initial password is “AAAA” as the factory default or when the [PROJECTOR SETUP] menu
→
[INITIALIZE]
→
[ALL USER DATA] is
executed.
f
Change the password periodically that is hard to guess.
f
To initialize your password, consult your distributor.