Chapter 1 Preparation — About your projector
ENGLISH - 27
r
Connecting terminals
7 8 9 10 11
1 2 3 4 5 6
1 <VIDEO IN> terminal
This is a terminal to input video signal.
2 <COMPUTER 1 IN> terminal
This is a terminal to input the RGB signal, YC
B
C
R
/YP
B
P
R
signal,
or Y/C signal.
3 <COMPUTER 2 IN/1 OUT> terminal
This is a terminal to input the RGB signal or YC
B
C
R
/YP
B
P
R
signal.
Also, the RGB signal or YC
B
C
R
/YP
B
P
R
signal input to the
<COMPUTER 1 IN> terminal can be output to an external
device. Video signal is output when the input is switched to
COMPUTER1.
4 <HDMI 1 IN> terminal/<HDMI 2 IN> terminal
This is a terminal to input the HDMI signal.
5 <DIGITAL LINK/LAN> terminal
This is a terminal to connect a device that transmits video signal
or audio signal via the LAN terminal. Also, this is the LAN terminal
to connect to the network.
6 <LAN> terminal
This is the LAN terminal to connect to the network.
This is a terminal to input audio signal. There are right input <R>
and left input <L>.
8 <SERIAL IN> terminal
This is the RS-232C compatible terminal to externally control the
projector by connecting a computer.
9
<AUDIO IN 2> terminal/<AUDIO IN 3> terminal
This is a terminal to input audio.
10 <VARIABLE AUDIO OUT> terminal
This is a terminal to output the audio signal input to the projector.
11 <DC OUT> terminal
This is the USB terminal dedicated for power supply. (DC5 V,
maximum 2 A)
This can be used when a power is needed to be supplied to a
wireless display adaptor, etc.
Attention
f
When a LAN cable is directly connected to the projector, the network connection must be made indoors.
f
To transmit the Ethernet and serial control signals using the <DIGITAL LINK/LAN> terminal, set the [NETWORK] menu → [ETHERNET
TYPE] to [DIGITAL LINK] or [LAN & DIGITAL LINK].
f
To transmit the Ethernet signal using the <LAN> terminal, set the [NETWORK] menu → [ETHERNET TYPE] to [LAN] or [LAN & DIGITAL
LINK].
f
The <DIGITAL LINK/LAN> terminal and the <LAN> terminal are connected inside of the projector when the [NETWORK] menu → [ETHERNET
TYPE] is set to [LAN & DIGITAL LINK]. Do not directly connect the <DIGITAL LINK/LAN> terminal and the <LAN> terminal using LAN cable.
Construct the system so that it is not connected to the same network via the peripherals such as the switching hub or the twisted-pair-cable
transmitter.
f
When the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to [NORMAL], the <DC OUT> terminal can
supply power even in standby state. If set to [ECO], the <DC OUT> terminal can not supply power in standby state.
f
When an external device exceeding the rating (DC 5 V, maximum 2 A) is connected to the <DC OUT> terminal, an error is detected and the
power supply will be stopped. At this time, disconnect the external device, cut o the power of the projector and then reconnect the power
plug to the outlet.
To Next Page
Loading...
