Panasonic PT-FRZ50 - [Noise Reduction]; [Dynamic Contrast]; [System Selector]; [Off]

Chapter 4 Settings — [PICTURE] menu
ENGLISH - 67
Operation Adjustment Range of adjustment
Press
w
. Contours become sharper.
0 - +15
Press
q
. Contours become softer.
Note
f
If you press
w
while the adjustment value is [+15], the value will become [0]. If you press
q
while the adjustment value is [0], the value will
become [+15].
[NOISE REDUCTION]
You can reduce noises when the input image is degraded and noise is occurring in the image signal.
1) Press
as
to select [NOISE REDUCTION].
2) Press
qw
or the <ENTER> button.
f
The
[NOISE REDUCTION]
individual adjustment screen is displayed.
3) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[OFF]
No correction.
[1]
Slightly corrects the noise.
[2]
Moderately corrects the noise.
[3]
Strongly corrects the noise.
Attention
f
When this is set for an input signal with less noise, the image may look di󰀨erent from the original image. In such a case, set it to [OFF].
[DYNAMIC CONTRAST]
Light adjustment of the light source is performed automatically according to the image to make the contrast
optimum for the image.
1) Press
as
to select [DYNAMIC CONTRAST].
2) Press
qw
or the <ENTER> button.
f
The
[DYNAMIC CONTRAST]
individual adjustment screen is displayed.
3) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[OFF]
Disables the dynamic contrast function.
[1]
Adjusts the light source and compensates signals to a small extent.
[2]
Adjusts the light source and compensates signals to a large extent.
Note
f
The brightness control function and the dynamic contrast function will operate simultaneously, but the dynamic contrast function will not
operate while measuring the brightness and the color.
[SYSTEM SELECTOR]
The projector will automatically detect the input signal, but you can set the system method manually when an
unstable signal is input. Set the system method matching the input signal.
1) Press
as
to select [SYSTEM SELECTOR].
2) Press the <ENTER> button.
3) Press
as
to select a system format.
f
Available system formats vary depending on the input signal.