Panasonic PT-JW130FWE - Page 114

Chapter 5 Operations — Web control function
114 - ENGLISH
Connecting with wireless LAN (USER1 to USER3)
1
2
3
4
5
6
8
9
10
7
7
7
1 [DHCP ON], [DHCP OFF]
To enable the DHCP client function, set [DHCP ON].
2 [IP ADDRESS]
Enter the IP address when you do not use a DHCP server.
3 [SUBNET MASK]
Enter the subnet mask when you do not use a DHCP server.
4 [DEFAULT GATEWAY]
Enter the default gateway address when you do not use a
DHCP server.
5 [DNS1], [DNS2]
Enter the primary DNS/secondary DNS server address when
you do not use a DHCP server.
6 [SSID]
Enter the same string as the SSID registered to the access
point.
7 [Back] button, [Next] button
Click the [Back] button to return to the previous screen. Click
the [Next] button to display a screen to conrm the settings.
Click the [Submit] button to update the settings.
8 [AUTHENTICATION]
Select the user authentication method used in the network to
which the projector is connected.
9 [EAP]
Select the EAP set for RADIUS server.
10 [ENCRYPTION]
Select the encryption method used for the communication
between the projector and the network.
Note
f The contents in the setting screen differ depending on the authentication method of the connected wireless LAN.
[Adjust clock] page
Click [Detailed set up] → [Adjust clock].
1
2
3
4
5
6
7
1 [Time Zone]
Select the time zone.
2 [Set time zone]
Updates the time zone setting.
3 [NTP SYNCHRONIZATION]
To synchronize with the NTP server and adjust the date and
time of the projector automatically, set it to [ON].
4 [NTP SERVER NAME]
Enter the IP address or server name of the NTP server when
synchronizing with the NTP server.
(To enter the server name, the DNS server needs to be set up.)
5 [Date]
Enter the date to be changed.
6 [Time]
Enter the time to be changed.
7 [Set date and time] button
Updates the date and time settings.
Note
f The battery inside the projector needs to be replaced if the time is reset when the power is turned on. Consult your dealer.