ENGLISH - 65
3) Press as to select [Curved correction].
4) Press the <ENTER> button.
f The [Curved correction] screen is displayed.
f The item switches in order of [Curved correction X/Y Gain] → [Curved correction X Offset] → [Curved correction Y
Offset] each time you press the <KEYSTONE> button on the remote control or the control panel.
5) Press asqw to adjust the item.
Items Operation Adjustment
[Curved
correction
X/Y Gain]
Press the w button.
The left and right vertical lines will be bulge.
Press the q button.
The left and right vertical lines will be dent.
Press the a button.
The top and bottom horizontal lines will be
bulge.
Press the s button.
The top and bottom horizontal lines will be
dent.
[Curved
correction X
Offset]
Press the w button.
Used to correct the right side vertical lines.
Extend the top and bottom while keeping
the center part as it is.
Press the q button.
Used to correct the left side vertical lines.
Extend the top and bottom while keeping
the center part as it is.
Press the a button.
Used to correct the both sides of the vertical
lines. Extend the lower corners while
keeping the center part and the upper part
as they are.
Press the s button.
Used to correct the both sides of the vertical
lines. Extend the top corners while keeping
the center part and the lower part as they
are.
[Curved
correction Y
Offset]
Press the w button.
Used to correct the right side horizontal
lines. Extend the top and bottom while
keeping the center part as it is.
Press the q button.
Used to correct the left side horizontal lines.
Extend the top and bottom while keeping
the center part as it is.
Press the a button.
Used to correct the both sides of the
horizontal lines. Extend the lower corners
while keeping the center part and the upper
part as they are.
Press the s button.
Used to correct the both sides of the
horizontal lines. Extend the top corners
while keeping the center part and the lower
part as they are.
Note
f Either [H/V Keystone] or [Corner correction] setting value is valid. If the other item is adjusted after [H/V Keystone] or [Corner
correction] was adjusted, the previous setting value will be reset.
f The [Curved correction X Offset] and the [Curved correction Y Offset] cannot be adjusted independently. After adjusting the
[Curved correction X/Y Gain] at the beginning, please adjust the [Curved correction X Offset] and the [Curved correction Y
Offset].
f Press the <KEYSTONE> button on the control panel or on the remote control when the [H/V Keystone], [Corner
correction] or [Curved correction] individual adjustment screen is displaying, the individual adjustment screen will switch
as follows.
- [H/V Keystone] [Corner correction] (Upper left) [Corner correction] (Upper right) [Corner correction] (Lower right)
[Corner correction] (Lower left) [Curved correction X/Y Gain] [Curved correction X Offset] [Curved correction Y
Offset] [H/V Keystone] ...
f Correcting up to ±30° for the tilt in the vertical direction and ±15° for the tilt in the horizontal direction are available for
adjustments with [Keystone]. However, the image quality will degrade and it will get harder to focus with more correction.
Install the projector so that the correction will be as small as possible.
f Screen size will also change when [H/V Keystone] is used to perform various adjustments.
f Aspect ratio of the image size may shift depending on the correction.
Chapter 4 Settings - [Expand] menu
To Next Page
Loading...
