Panasonic PT-LB75VE - Switching off the Projector

Switching the projector on/off
Basic Operation
24 -
E
NGLISH
Switching off the projector
When operating the projector, check the status of the POWER indicator. (
¨
page 22)
INPUT SELECT
RELEASE
POWER indicator
POWER LOCK indicator
(1), (2)
Press the POWER button.1)
7KHFRQ¿UPDWLRQVFUHHQZLOOEHGLVSOD\HG
Without any operation for 10 seconds or press any button other than the
z
POWEREXWWRQWKHFRQ¿UPDWLRQ
screen will go off and return to the projection.
Press the POWER button again.2)
The lamp goes off, the operational sound (beep) sounds, and projection stops.
The cooling fan continues its rotation and
z
POWER indicator lights in orange. Wait until the POWER LOCK
indicator and POWER indicator turn into red.
If
z
STANDBY MODE is set to NORMAL, the POWERLQGLFDWRUÀDVKHVLQUHG(
¨
page 42)
You can set to
z
ON or 2)) the beeping sound that occurs when the POWER button is in operation in
AUDIO SETTING.
(
¨
page 43)
After the POWER LOCK indicator and POWER indicator light in red, disconnect the 3)
PDLQVSOXJIURPWKHPDLQVVRFNHW(
¨
page 21)
For urgency, you may disconnect the mains plug immediately since the
z
',5(&732:(52)) function is
installed.
5HPDUNV
&RQ¿UPWKDW
z
CONTROL PANEL (when operating with the projector body) or REMOTE CONTROLLER (when
operating with the remote control) under
CONTROL DEVICE SETUP in the SECURITY menu is set to ENABLE .
(
¨
page 46)
You can switch off the power by pressing the
z
POWER button for 0.5 seconds or more.