ENGLISH - 35
r For PT-LB303
Audio equipment
Control computer
Computer
Computer
Control computer
Attention
f When connecting the projector to a computer or an external device, use the power cord supplied with each device and
commercially available shielded cables.
Note
f If you operate the projector using the computer with the resume feature (last memory), you may have to reset the resume
feature to operate the projector.
f When the <VARIABLE AUDIO OUT> terminal is connected with cable, the sound will not be output from the built-in speaker.
f The video signal from the DVD-D terminal of the external device (such as a computer) is connect to the <HDMI IN> terminal
by using a conversion cable, the [Setting] menu → [HDMI setup] → [Sound] is set to [Computer] (x page 61) and the
audio signal will be input to the <AUDIO IN 1> terminal.
Chapter 2 Getting Started - Connecting
To Next Page
Loading...
