Panasonic PT-LW375 - Powering on the Projector; Making Adjustments and Selections

40 - ENGLISH
Powering On the Projector
Before switching on the projector, make sure all the other devices are correctly connected. (
Æ
page 34)
2) 1)
3)
3)
1) Connect the power cord to the projector body.
2) Connect the power plug to an outlet.
f The power indicator <ON(G)/STANDBY(R)> lights in red, and the projector will enter the standby mode.
3) Press the power <v/b> button.
f The power indicator <ON(G)/STANDBY(R)> lights in green and the image is soon projected on the screen.
Making adjustments and selections
It is recommended that images are projected continuously for at least 30 minutes before the focus is adjusted.
3)
5)
3)
1) Roughly adjust the focus of the image with the focus ring. (x page 43)
2) Change the settings of the [Display] menu → [Project way] depending on the installation mode.
(x page 56)
f Refer to “Navigating through the menu” (x page 51) for the operation of the menu screen.
3) Press the <INPUT/ENTER> button on the control panel or the input selection (<COMPUTER 1>,
<COMPUTER 2>, <HDMI>, <VIDEO>, <MEMORY VIEWER/USB DISPLAY/NETWORK>) buttons on the
remote control to select the input signal.
f The <COMPUTER 2> button is only for PT-LW375, PT-LW335, PT-LB425, PT-LB385 and PT-LB355, it is disabled for
PT-LB305.
f The <MEMORY VIEWER/USB DISPLAY/NETWORK> button is only for PT-LW375, PT-LW335, PT-LB425, PT-LB385
and PT-LB355. The <MEMORY VIEWER/USB DISPLAY> button is for PT-LB305 and it is disabled.
4) Adjust the projection angle of the projector with the adjustable foot. (x page 44)
5) If the input signal is an analog RGB signal, press the <AUTO SETUP> button.
6) Adjust the size of the image to match the screen with the zoom ring.
7) Adjust the focus with the focus ring again.
8) Adjust the size of the image to match the screen with the zoom ring again.
Chapter 3 Basic Operations - Powering on/off