Panasonic PT-MZ10K - Page 173

Chapter 5 Operations — Web control function
ENGLISH - 173
Lens position setting page
Click [Projector control] → [Detail control] → [LENS] → [SET POSITION].
4
3
2
1
1 [Get]
Acquires the current lens position and displays the acquired
values in the lens position information eld.
2 Lens position information eld
Enters the lens position (vertical position/horizontal position).
3 [Back]
Returns to the [LENS] page.
4 [Apply]
Moves to the lens position displayed in the lens position
information eld.
[Network cong] page
Click [Detailed set up] → [Network cong].
f Click [Network cong] to display the [CAUTION!] screen.
f Click [Next] to display the current setting.
f Click [Change] to display the setting change screen.
1
2
3
4
5
6
7
8
1 [PROJECTOR NAME]
Enter the name of the projector. Enter the host name if it is
required when using a DHCP server etc.
2 [DHCP ON], [DHCP OFF]
To enable the DHCP client function, set to [DHCP ON].
3 [IP ADDRESS]
Enter the IP address when not using a DHCP server.
4 [SUBNET MASK]
Enter the subnet mask when not using a DHCP server.
5 [DEFAULT GATEWAY]
Enter the default gateway address when not using a DHCP
server.
6 [DNS1]
Enter the DNS1 server address.
Permissible characters for the entry of DNS1 server address
(primary):
Numbers (0 - 9), period (.)
(Example: 192.168.0.253)
7 [DNS2]
Enter the DNS2 server address.
Available characters for the entry of DNS2 server address
(secondary):
Numbers (0 - 9), period (.)
(Example: 192.168.0.254)
8 [Back], [Next]
Click [Back] to return to the original screen. Click [Next] to
display the setting conrmation screen. Click [Submit] to update
the setting.
Note
f When you use the “Forward” and “Back” functions of your browser, a warning message “Page has Expired” may appear. In that case, click
[Network cong] again since the following operation will not be guaranteed.
f The connection may be disconnected when the LAN setting is changed while connected with LAN.