EasyManua.ls Logo

Panasonic PT-RQ35K - Page 326

Panasonic PT-RQ35K
331 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 7Appendix — Specications
326 - ENGLISH
List of simultaneous input compatible signals
The following table species the simultaneous input compatible video signals that the projector can project.
Signal name
(SIGNAL FORMAT)
Resolution
(Dots)
Scanning freq.
Dot clock freq.
(MHz)
Simultaneous input compatible
signal
Horizontal
(kHz)
Vertical
(Hz)
HDMI
*1
DisplayPort
*2
SDI
*3
3840 x 2160/60 3 840 x 2 160 135.0 60.0 594.0
l
*4
l l
4096 x 2160/60 4 096 x 2 160 135.0 60.0 594.0
l
*4
l l
*1 This is supported when the optional Interface Board for HDMI 2 input (Model No.: ET-MDNHM10) is installed in both of the slots.
*2 This is supported when the optional Interface Board for DisplayPort 2 input (Model No.: ET-MDNDP10) is installed in both of the slots.
*3 This is supported when either of the optional Interface Board for 12G-SDI (Model No.: ET-MDN12G10) or the optional Interface Board for 12G-SDI
Optical (Model No.: ET-MDNFB10) is installed in both of the slots.
*4 When performing the simultaneous input of the 4K image (resolution of 3 840 x 2 160 or 4 096 x 2 160) using the Interface Board for HDMI 2 input
(Model No.: ET-MDNHM10), it is necessary for the rmware version of the Interface Board for HDMI 2 input to be 2.00 or later. If the version is
earlier than 2.00, the simultaneous process is not performed even if corresponding signal is input. Consult your dealer regarding the version update
to the latest rmware.
For details on how to conrm the rmware version, refer to “How to conrm the rmware version of the Interface Board (optional)” (x page 38).
Note
f Input of the video signal in simultaneous format is supported when the main version of the rmware is 1.07 or higher. Input of the video
signal in simultaneous format can be supported by updating the rmware if the main version is lower than 1.07.
Check the Panasonic website (https://panasonic.net/cns/projector/pass/) for availability of the rmware that can be updated.
For details on how to update the rmware, refer to “Updating the rmware” (x page 277).

Table of Contents

Related product manuals