Panasonic PT-RZ990 - Page 63

Chapter 3 Basic Operations — Switching on/off the projector
ENGLISH - 63
Initial setting (standby mode)
Set the operation mode during standby. The factory default setting is [NORMAL], which allows you to use the
network function during standby. To keep power consumption low during standby, set this item to [ECO].
After completed the initial setting, you can change the setting from the [PROJECTOR SETUP] menu
→
[STANDBY
MODE].
1) Press
qw
to switch the setting.
4/7
When set to ECO,
network functions and SERIAL OUT terminal,
and some RS-232C commands are not available
during standby.
INITIAL SETTING
SET
CHANGE
STANDBY MODE
NORMAL
ENTER
2) Press the <ENTER> button to proceed to the initial setting.
Initial setting (screen setting)
Set the screen format (aspect ratio) and display position of the image.
After completed the initial setting, you can change the settings of each item from the [DISPLAY OPTION] menu
→
[SCREEN SETTING].
1) Press
qw
to switch the setting.
f
The setting will change each time you press the button.
16:10
5/7
SCREEN POSITION
Set as necessary for the screen in use.
INITIAL SETTING
SET
CHANGEMENU SELECT
SCREEN FORMAT
ENTER
2) Press
as
to select [SCREEN POSITION].
f
[SCREEN POSITION] cannot be selected or adjusted when [SCREEN FORMAT] is set to [16:10].
3) Press
qw
to adjust.
16:9
0
5/7
SCREEN POSITION
Set as necessary for the screen in use.
INITIAL SETTING
SET
CHANGE
SCREEN FORMAT
ENTER
MENU SELECT