Chapter 4 Settings — [POSITION] menu
98 - ENGLISH
[CORNER CORRECTION]
[FREE GRID]
Finer adjustment is possible by selecting the points or lines to be corrected.
For details of operation, refer to “Adjusting distortion with [FREE GRID]” (
x
page 98).
Adjusting to desired linearity
1) Press
as
to select [GEOMETRY].
2) Press
qw
to select [CORNER CORRECTION].
3) Press the <ENTER> button.
f
The
[GEOMETRY:CORNER CORRECTION]
screen is displayed.
4) Press
as
to select [LINEARITY].
5) Press
qw
to select [MANUAL].
6) Press the <ENTER> button.
f
The
[LINEARITY]
screen is displayed.
7) Press
asqw
to adjust.
Adjusting distortion with [FREE GRID]
1) Press
as
to select [GEOMETRY].
2) Press
qw
to select an item other than [OFF].
3) Press the <ENTER> button.
f
The screen for the selected item is displayed.
4) Press
as
to select [FREE GRID].
5) Press
qw
to select an item.
f
The items will switch each time you press the button.
[OFF]
Disables the adjustment to be performed with [FREE GRID].
[ON]
Enables the adjustment to be performed with [FREE GRID].
f
Proceed to Step
6)
when [ON] is selected.
6) Press the <ENTER> button.
f
The
[FREE GRID]
screen is displayed.
7) Press
as
to select [GRID RESOLUTION].
8) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[2x2]
Performs the adjustment using the pattern of the outer border (there are two lines each vertically and
horizontally as a grid line).
[3x3]
Performs the adjustment using the grid pattern divided into two in the horizontal direction and also in
the vertical direction.
[5x5]
Performs the adjustment using the grid pattern divided into four in the horizontal direction and also in
the vertical direction.
(Factory default setting)
[9x9]
Performs the adjustment using the grid pattern divided into eight in the horizontal direction and also in
the vertical direction.
[17x17]
Performs the adjustment using the grid pattern divided into 16 in the horizontal direction and also in
the vertical direction.
9) Press
as
to select [CONTROL POINTS].
To Next Page
Loading...
