Panasonic PV-4601 A - Page 30

Fig. 12-2
(Removal and Installation of the Flat Cable)
Type A
(Removal)
Pull out the Flat Cable. Minimize stress by holding it securely to avoid damage of the
individual wires. (See
Fig. 12-3.)
(Installation)
Adjust the position of the Flat Cable so that the Identification
Line on the Flat Cable aligns with Pin 1 of the Trap Connector and align the individual
wire with its individual Trap Connector Hole. Then insert the Flat Cable wire into the
Trap Connector.
30