Panasonic PV-C2541 - Page 23

«Important: — if a remote control button does not work when pressed. press the COMBO button on
the remote and try the button again.
Review, Replace or Clear Program
Cancel a Timer Recording:
Contents : (Recording is not in progress)
(Recording is in progress)
Hold down STOP for a few seconds 1 Repeat steps 1 and 2 on page 22.
to cancel the Timer Recording.
* Any future daily or weekly recordings
WI be Bored as Pog: P pr sant sme ey sro) Press AY to select
9:00p12:004 08 SP *
the desired program.
4 SU 9:00p10: 00p L
CANCEL : ADD/DLT
Perens. 1-8:4 Y
END :PROG/ ACTION
3 To Replace program...
R START — STOP — CH 1) Press P to display.
Fu AURA} 2) Press AV to select
and press «4 or»
SELECT START DATE to set new program
SELECT:
END — :PROG/ACTION contents.
3) Press PROG/VCR+
button (or ACTION).
To Clear program...
= START or CH SPD Press ADD/DLT.
SELECT 1-B:a Y
Hd
END ; PROG/ACT ION
Press PROG/VCR+ button twice
(or ACTION) to exit this mode.
¡Notes
* 2 minutes before Timer recording is performed,
“PLEASE PREPARE FOR TIMER REC” appears
and/or the PROG TIMER Indicator flashes.
Be sure a cassette with record tab is loaded and the
unit is in Stop mode.
e If the start times of two programs overlap, the lower
numbered program will have priority.
+ If the start time for a Timer Recording comes up
during a normal recording or One Touch Recording
(page 14), the Timer Recording will not be performed.
e If there is a power interruption of more than one
minute, the recording may not be performed or
continued.
* If “INCOMPLETE” appears after all items have been
set, check all entries and make necessary
corrections.
23