Panasonic PV-C2541 - Page 25

Important:
if a remote control button does not work when pressed. press the COMBO button on
the remote and try the button again.
[V Ready Check List
O The clock is set to correct time.
O VCR Plus+ System Setup is
complete. (See page 24.)
Use normal Timer Recording steps if:
* a program PlusCode programming number
is not listed.
* program, such as a sporting event, may run
over scheduled stop time.
See page 23 to:
* cancel a timer recording in progress.
* replace program contents.
* review or clear program contents once set.
* You can obtain unlisted PlusCode
programming numbers by calling
1-900-454-7587.
Call costs approximately $0.95 per minute.
* Avoid overlapping program times.
* if you're using a cable box, make sure that
it is tuned to the desired channel and the
power is left on for timer recording.
* Timer programs memory capacity is 8.
To add more programs, please first clear
other programs. (See page 23.)
* Make each entry within 5 minutes or the
unit will leave this mode.
* Once local channels have been
programmed, they will stay in memory,
even in the case of a power failure.
SELECT/
4:VOL DOWN
24/7 PROGNCR+
NUMBER
Keys
VCR Pius+ System Programming
Press PROG/VCR+ button
to display SET PROGRAM screen.
1) Press AY to select
VCR Plus+
PROGRAMMING.
2) Press > to display
screen.
1) Press number keys
to enter PlusCode
programming number.
2) Press PROG/VCR+
button when finished.
To Make Corrections
Press «4 repeatedly to delete
the PlusCode programming number.
VCR Plus+ SYSTEM 1) Press AY to select
and P to set
DAILY (MON-FRI)
WEEKLY
Record Frequency.
and > to set
Category and
Record speed.
Selections:
* Categories > N/A (not applicable), SPORTS,
MOVIE, COMEDY, MUSIC, or DRAMA
* Speed 3 SP, LP, or SLP
To Make Corrections
Press € >> to move the cursor and ÀV to make the
correction.
o) Press PROG/VCR+
button (or ACTION.)
to end programming.
P OT START STOP CH SPD
1 day 9:00p 12:00 08
Q --i---i-
4 -- water mete -~
CANCEL : ADD/DLT
SELECT 1-8:A Y
ENTER :»
END ;PROG/ACTION
Press PROG/VCR+ button twice
(or ACTION) to exit this mode.
+ PROG TIMER indicator lights on the unit.
25