Panasonic PV-C2541 - Page 30

Tape
Operation
(continued)
Repeat Play
Set to sée a recording over and over.
Press ACTION*
to display MAIN MENU.
1)Press AV4»
to select “VCR.”
2)Press ACTION
to display SET
UP VCR screen.
SET UP VCR 1)Press AY to
foam) Select “REPEAT
TIME STAMP 1 PLAY."
pao 2) Press > to set
pm ROS
Press ACTION twice
to end setup.
Zero Search
To quickly retum to a specific tape counter location.
Press DISPLAY during playback
to display the Counter.
Press COUNTER
99:9 RESET at the
desired position to
reset to "0:00:00."
3 Continue playback, rewind, or
fast forward.
4 Press STOP.
5
Press CM/ZERO
in stop mode to
start ZERO
SEARCH.
* Y : Present position mark
V 7 Zero position mark
* Unit goes into FF or REW mode and
Stops at the last point the Counter was
Set to 0:00:00.
For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts @ panasonic.com
Commercial Skip
By pressing the CM/ZERO button in Playback
mode you can skip over 1 to 3 minutes of
recorded tape in just a few seconds.
Press CM/ZERO repeatedly to
select skip time in Playback mode.
* No indication appears.
OFF
y
1st Press — 1 min Skip
2nd Press —«2 min Skip
3rd Press —*«3 min Skip
Repeat Play Notes -
* Playback repeats when tape end is reached
or unrecorded portion over 30 seconds is
detected.
* During playback, you may also press
PLAY/REPEAT repeatedly on the unit to
select REPEAT "ON" or "OFF."
SELECT/
SET
4.CH UP
v:CH DOWN
»:VOL UP
4: VOL DOWN
Zero Search Note
* If a blank portion exists on the tape, and
depending on the position of the Y mark,
the Y mark display may be out of position.